Typical applications areas where our non-inductive bulk resistors are utilized include RF amplifiers and generators, broadcasting equipment, motor controls, power conditioning and X-ray/CAT scan equipment, defibrillator and patient monitoring, relays and circuit breakers, high voltage and laser power supplies, plus pulse power testing equipment. (read more)

As safety devices for the protection of valuable equipment, ceramic resistors can absorb and dissipate high-energy surges. Resistor size can vary from very small to as large as 5 1/2" diameter by 2.0" thick. (read more)

As safety devices for the protection of valuable equipment, ceramic resistors can absorb and dissipate high-energy surges. Resistor size can vary from very small to as large as 5 1/2" diameter by 2.0" thick. (read more)

Resistor Tubes are available in a wide assortment of diameters and lengths to meet your application needs. Standard applications include high power loads, snubber circuit RF power amplifiers, and impulse voltage generators. (read more)

Resistors spotted at high-voltage ignition load points will limit spurious high-frequency signals from being emitted or carried on transmission lines. Typical examples are spark plugs, distributor points, and coil leads. Moving contact within the distributor caps presents no problems or interference when a brush-type resistor is used. (read more)

These resistors are used to decrease line voltage to a usable operating voltage. Applications are found in specialty lighting equipment and thermostats. (read more)

High Input Power? IMS' N-Series of resistors and terminations on aluminum nitride offer unmatched power handling and flexibility in meeting your specific circuit requirements. (read more)

High Power - Low Capacitance Resistor Series

20 to 250 watts, this new Resistor Series is specifically designed to offer maximum power performance WITH low capacitance in Power Combiner and Divider applications. When designing your Wilkinson Power Combiner or Divider, this series eliminates the need to choose either High Power or Low Capacitance; now you can have both. (read more)

Barry Industries announces their line of Power Terminations, Attenuators, and Resistors for WiMax applications, specifically for 3.4 – 3.6 GHz.

Devices are available in a selection of configurations, from chip, to a leaded chip, to a flange mounted device, with power ratings from 20 to 200 watts depending on your design needs. (read more)

Attleboro, MA 02703 - Barry Industries announces their line of Pulsed Power Devices specifically designed for hi-rel, thermally cycled devices.

Devices are derated up to 250 degrees C. These terminations and resistors are ideal for use in solid state laser technology, and plasma RF generators that have an operating frequency of 13.56 MHz. (read more)